Gaine thermorétractable CellPack 204310, longueur 10 m, conditionnement individuel

CellPack 204310 heat-shrink tubing is supplied as a continuous 10 m length in a single pack and is intended for insulating, protecting and sealing electrical joints and cables. The tubing reduces in diameter when heat is applied, forming a close-fitting and mechanically stable cover that resists abrasion and environmental exposure. It is compatible with common wiring repair tasks, cable harness assembly and general electrical insulation needs in electronics, automotive and household applications.

Advantages

The heat-shrink tubing delivers a uniform shrink ratio along its length to produce a consistent fit around wires and connectors. Supplied as a long, single-length roll, it allows cutting to required sizes and reduces the need for multiple short pieces. The material provides electrical insulation, mechanical protection against chafing and additional sealing against moisture when correctly applied. The product's flexibility enables use on curved or bundled cables while maintaining dielectric properties.

Suitable for

Key specifications

How to use

Select a length of tubing slightly longer than the area to be covered, slide it over the connector or splice before completing the joint when possible, or position it over the exposed area. Apply heat evenly along the tubing using a heat gun or another appropriate heat source until the tubing shrinks uniformly and conforms to the underlying shape. Allow the tubing to cool and set before handling. Cut with scissors or a utility knife to required lengths; sections may be tied together on the spool, so inspect and separate before cutting.

Recommendations

For consistent results, warm the tubing gradually from a distance and rotate the cable during heating to ensure even shrinkage. Avoid direct prolonged flame contact to prevent scorching. Use the tubing with appropriate diameter relative to the components so that the final shrink provides a snug fit. Store the roll in a cool, dry place away from direct sunlight to preserve material properties.