Câble haut-parleur InLine 2x 0,75 mm² CCA transparent 50 m

The InLine Speaker Cable 2x 0.75mm² CCA transparent 50m is a two-conductor speaker cable with copper-clad aluminium (CCA) conductors and a transparent outer jacket. It provides a lightweight, flexible solution for routing low-voltage speaker connections over distances up to 50 metres. Note: this cable is not approved for use with electroacoustic (ELA) 100V speaker systems.

Advantages

The CCA construction offers a balance of conductivity and reduced weight compared with solid copper, while the 0.75 mm² cross-section is suitable for short to medium runs of typical consumer and installation speakers. The transparent jacket allows discreet placement and easy visual inspection of the cable, and the flexible design simplifies installation along walls or behind furniture.

Suitable for

• Home audio speaker connections
• Small commercial audio installations (low-voltage systems)
• Routing between amplifier/receiver and passive speakers
• Temporary event audio setups with short to medium cable runs

Key specifications

• Conductors: Copper-clad aluminium (CCA)
• Configuration: 2 conductors
• Conductor cross-section: 0.75 mm²
• Length: 50 m
• Colour: Transparent
• Connectors: None (sold as bare cable)

How to use

Strip the outer jacket and the individual conductor insulation to expose the conductors, then connect to speaker terminals and amplifier/receiver outputs observing correct polarity. Use appropriate cable connectors or soldering where required and ensure secure mechanical fastening to prevent strain on the terminations. Route the cable to avoid sharp edges, heat sources and high-voltage power lines.

Recommendations

Do not use this cable for 100V electroacoustic (ELA) systems; it is intended for low-voltage speaker lines. For longer runs or higher power speakers, consider a larger conductor cross-section or pure copper cables to reduce voltage drop and improve performance.